Instructions Best — Bradex Bx60 Battery Charger

| Problem | Probable Cause | Solution | |---------|----------------|----------| | Fault LED on solid | Battery voltage too low (<3V) | Try a manual charger to “wake up” the battery, or replace battery. | | Fault LED flashing | Reverse polarity | Swap the clamps immediately. | | Charger won’t start | No AC power or bad connection | Check outlet, check extension cord gauge (min 16 AWG). | | Red LED stays on for >24 hours | Very large battery or battery has shorted cell | Stop charging. Test battery. Replace if needed. | | Green LED flashing forever | Battery unable to reach full charge (internal resistance high) | Battery aging. Run desulfation cycle for 48 hours. If no change, replace battery. |

Two hours later, over a thermos of coffee, Mark checked the progress. The bars were full. The BX60 had transitioned to a green "Charged" light. He disconnected in reverse order—Black first, then Red. bradex bx60 battery charger instructions best

: Always charge in a well-ventilated area, as batteries can release flammable gases during the process. | Problem | Probable Cause | Solution |

Enter the . This compact, robust little unit has become a staple in home garages and workshops due to its straightforward design and reliability. However, like any piece of electrical equipment involving lead-acid batteries and power outlets, using it correctly is paramount for both safety and the longevity of your vehicle. | | Red LED stays on for >24

Connect the clip to the positive terminal of the battery.

Following the correct sequence prevents sparks and protects your car’s electronics.

Connect the negative (-) black crocodile clip to the negative terminal. Plug into Power: