Rf300 Installation Manual — Simrad
Ensure the feedback arm and the rudder arm are parallel when the rudder is in the dead-ahead position. The transmission link should be at a 90-degree angle to both arms. Connection:
: Use blocking material if necessary to keep the transmission arm level. simrad rf300 installation manual
Position the unit so the feedback arm is as close to parallel with the rudder arm as possible when the rudder is amidships. If the geometry is off, your autopilot will get "confused" by non-linear readings. 2. Making the Connection Ensure the feedback arm and the rudder arm
The is a rotary rudder feedback unit that converts physical rudder movement into a frequency signal for an autopilot computer. Proper mechanical alignment is critical during installation to avoid rudder feedback alarms. Mechanical Installation Center Alignment: Before mounting, rotate the Position the unit so the feedback arm is
The RF300 is a two-wire frequency-based sensor (3400Hz center, 20Hz/degree). Terminals: Connect the cable to the dedicated Rudder Feedback terminals on your autopilot computer.
